If you connect all your cameras to a network switch and then use this IR command: This is by far the easiest method for setting up the cameras and you don't technically need a computer on the network to do this. Using this method, you can keep the ethernet video traffic isolated to a local network you have just for AV gear. Setting up the cameras on an isolated network, without a connection to the router on site. You should be prompted for a username and password (both: admin), and now your camera is set up to be on your network! You can pull this feed into numerous other places including using our free camera control app to view and control the cameras. If you get a different IP address, that is most likely the correct IP address for your network.Once this is done, if the IP address is 192.168.100.88, either the camera is not connected to your router, or the router is not capable of changing the IP address using DHCP, proceed to the next step.If you can't get a live image, try changing the rotary dial on the back of the camera to setting B and then reboot the camera. Press this * > # > 4 in sequence to see the current IP address is (below).To find out what that IP address is, connect a monitor or display to the HDMI output of the camera to see the live image. Once the camera has rebooted, it should have the correct IP address to access it on your network.The camera will reboot after receiving this command. If you know that this camera is connected to a DHCP router, the camera will find it's own DHCP address. This will place the camera into DHCP mode. Please Note: The router should be the device supplying internet to your site. Press # > * > 4 in sequence using the supplied IR remote control.Connect your camera to your wireless router, or to a switch connected to the wireless router.Please Note: This will only work for the cameras that have an IR remote control. This adds it to your network's range with minimal effort. The easiest way to get the PTZOptics unit connected to your network is to connect the camera to your wireless router and then enter the command to let the camera find the IP address assigned by the router. If you plan on setting up an isolated network, without a connection to the router on site and your cameras are connected to the computer via a switch, use the setup guide at the end of the article. Use this setup if your cameras are connected to your onsite router. Setting up the cameras with a connection to the router on site. Solution home PTZOptics Quick Start Section How do I get the PTZOptics camera up on my network (Quick Setup)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |